What's Included 

How to Install

Step 1

Separate your Thumbstick components

Step 2

Clean the front and back of your device or case

Step 3

Load up your game of choice

Step 4

Identify your Virtual Joystick

Step 5

Peel and place your an Achor sticky disk on the rear of your phone, behind your Virtual Joystick. 

(you might not need this step. It helps keep your Anchor secure on with more slippery surfaces)

Step 6

Place your anchor on the rear of your phone, over the Anchor sticky disk.

Step 7

Place your Thumbstick on Top

Step 8

Equip your Thumb Sleeve, on your right hand

Step 9

Calibrate your display

For reliable touch performance when using PuK products, we recommend that you do this once before each session to allow your display to set it's capacitive baseline with PuK products installed. Most of the time it won't be necessary and you might only need to follow this process if touch issues occur.

1. Attach all touch-interface devices (Triggers and PuK Thumbstick)
2. Load your game of choice
3. Tap the power button to put the display to sleep (it’s ok if you need to shift a trigger sideways to gain access to the device power button)
4. Wait 10 seconds
5. Press the power button again to wake the phone and unlock the device if necessary

Calibration complete

Setup complete

For more tips to optimize your PuK experience, review our Touch Interface Troubleshooting and Optimisation Guide.

For tips on game specific settings, check out our Game Guides.